Redsail Cutting Plotter User Manual
V4.0
Plotting pen:
You can use usual ball pen as plotting pen; keep the ball pen peep out of the
holder between 4mm and 5mm. the other using method is similar as blade's
process; please try it yourself according to the blade's changing method.
Set the knife holder or pen holder on holder's seat:
Turn off the plotter power.
Set the holder on holder's seat, close the screw of seat of holder.
Turn on the power, the carriage will move to right side; you can press "TEST" key
to examine the plotter.
Load media /Load paper
Load media /Load paper:
When you move the roller, you must lift the handle first; the right roller will not
move, usually.
Lift the handle, the roller will lift 1-2mm, then you can load your media.
Laying down the handle, you can press "UP" key (S+) or "DOWN" key (S-)
continuously, the paper will roll to front or back; please confirm the paper must
move straightly during the distance that you want to cut.
Adjust the speed and pressure, and then you can output the data to the plotter.