Fault Alarms - Oki ML390 Service Manual

4.5 FAULT ALARMS

4.5.01 General Information
The operator panel is used to display printer modes and error conditions. The table below shows the
operator panel display and the mode or condition it matches.
Printer Modes
Microline 390/391
ALARM SELECT
Lamp Lamp Status
Status
OFF ON
OFF ON
OFF OFF
OFF OFF
ON OFF
ON OFF
ON OFF
OFF BLINK
Service Guide ML390/391
Chapter 4 Failure & Repair Analysis
MENU Printer
Lamp Mode
Status
N/A Normal
Operation
N/A Normal
Operation
N/A Normal
Operation
ON Normal
Operation
N/A Operator
Alarm
N/A Operator
Alarm
N/A Operator
Alarm
N/A Operator
Alarm
Status Description
On-Line The printer is ready
to receive data and
to print.
Hex Dump The printer is in Hex
Dump Mode. Refer
to Section 4.7
Off-Line The printer will NOT
receive data or
print.
Menu The operator may
Mode view or change the
menu settings.
Paper End Printer is out of
paper.
Paper SASF paper jam
Jam
CSF Paper jam or paper
Paper end with CSF
Jam installed.
Print The printer has
Suppress received a PRINT
SUPPRESS code
from the computer.
Page: 83