Advertisement
Maintenance
Attention To Maintenance
Cabinet maintenance
After using the washing machine , wipe
the moisture and stain on it with a
piece of soft cloth. To avoid damage
to the surface , do not use corrosive or
volatile chemicals.
Anti-freezing protection
To prevent from freezing:
Turn off the water tap, remove the water inlet hose and empty water in the water inlet
hose completely.
Lay the drain hose and turn the drain selector knob to the "Drain"position to
empty the water in the tub.
If the water is frozen, please take the following steps:
Put the water inlet hose into warm water of about 50℃.
Keep about 2 liters of warm water below 50℃ in the wash tub for
about 10 minutes. and then lay the drain hose and turn the
wash drain selector knob to the "Drain"position to empty the water .
Fit the water inlet hose and turn on the water tap to
confirm water filling and draining work properly.
Operation when objects are
dropped into the outside of the spin tub
Remove all screws on the frame with a screw driver.
Pull up the frame with both hands and turn it backwards.
Take out the clothes dropped into the outside of the spin tub.
Press the frame to reset and tighten screws.
After you use the washing machine, never forget to do the following two things:
1. Disconnect the power plug.
2. Remove the water inlet hose.
Cleaning the lint filter
1.Press the button head, and
pull the lint filter out.
Turn the filter net inside out, and rinse it
in water.
After inserting the claw, press the button
to insert it into place.
A click sound means proper installation.
Button head
Claw
Frame
Cabinet
6
Others
Notes
The washing machine employs alternative current with rated voltage and frequency . When voltage fluctuates
between -10% and 10% of the rated voltage, the machine can work normally.
Connection mode of the power cord of this machine is Y-shaped connection. Users
or reconnect the wire by themselves.
If this part needs to be repaired,
After using, be sure to unplug the power plug.
Be sure to use plug that is properly grounded.
The maximum gradient of the supporting surface for the washing machine should not exceed 2
Do not tear down electrical wires and components in the machine by yourself.
There are holes on the base for ventilation. These holes should not be blocked by foreign objects (carpets, etc.).
Never connect the grounding wire with the live wire, or it may lead to an electric shock.
If the power cord is damaged, it must be replaced by a qualified person to avoid a hazard.
If the following symptoms occur, please disconnect the power plug and perform the following
checks:
Symptom
Check that the power supply is in good condition.
The washing
Check that the power plug is inserted properly.
machine does
Check that the wash timer knob or the spin timer knob is not
not work.
in the "0" position.
Check that the drain hose is not laid too high.
The drain hose
Check that the drain hose is not frozen.
does not work.
Check that the drain hose is not blocked by foreign matter.
There is abnormal
Check that there are no coins or any other foreign
noise during washing.
objects dropped into the wash tub.
Check that the washing machine is placed on flat, stable floor.
There is abnormal
Check that clothes are evenly distributed in the spin tub.
noise and violent
Check that there are no washing materials or foaming debris
vibration during
dropped into the outside of the spin tub.
spinning.
should not detach
please contact the designated service center.
º
.
Reason
7
Hide quick links:
Advertisement
