Replacing The Main Brush Roller - Kärcher KMR 1250 B User Instructions

English
Replacing the main brush
roller
Brush roller seen from above
Direction of travel
48
User Instructions
n Park the sweeper and switch off the engine
n Lower the brush roller.
n Open the RH side flap
n Undo the retaining bolt on the lower forked head
swivel the push rod towards the rear.
n Unscrew the knurled knob
n Remove the oscillating linkage
n Open the flap over the end of the brush roller
fastener).
n Pull out the brush roller
n Screw in the knob for adjusting the sweeping pattern as
far as it will go (clockwise, towards –).
n Fit the new brush roller in reverse order to the removal
procedure.
Note:
Make sure the bristles point in the right direction – see
illustration.
n Set up the sweeping pattern by turning the adjusting knob
– see "Adjusting the sweeping pattern".
1
(seen in direction of travel).
3
.
4
.
6
.
KMR 1250 B
2
and
5
(turn-lock