Vhf Com; Table 2-10A11 - Arinc 429 O - Garmin GNS 480 Installation Manual

Table 2-10A11 - ARINC 429 Output Labels – Configuration 5 (ARINC 743A)
Label No. Parameter Name
Refer to section 3.2.1.2 for information on configuring the ARINC 429 outputs.
2.8.11 T M
IME ARK
P1-17 Time Mark Out +
P1-19 Time Mark Out -
The Time Mark Out is a differential output that provides a 1 msec pulse once each second. This time
reference is derived from GPS satellites.
2.8.12 VHF C
OM
The GNS 480 provides an internal COM transceiver that can be interfaced to an audio panel or connected
directly to a speaker. The PTT input is used to enable the Com MIC audio and cause the Com
transceiver to transmit on the active frequency. Optional external inputs are available to allow the user to
toggle the active and standby Com frequencies, and select Com frequencies from a user-defined
frequency list.
Refer to Appendix D for interconnect information.
Refer to section 3.2.1.5 for information on setting the RF squelch and mic gain values.
GNS 480 (CNX80) Installation Manual560-0982-01 Rev A
076 GNSS Altitude (MSL)
101 HDOP
102 VDOP
103 GNSS Track Angle
110 GNSS Latitude
111 GNSS Longitude
112 GNSS Ground Speed
120 GNSS Latitude Fine
121 GNSS Longitude Fine
125 UTC Time Of Day [BCD]
130 Horizontal Protection Level
133 Vertical Protection Level
136 Vertical Figure of Merit
140 UTC Fine
141 UTC Fine Fractions
150 UTC Time Of Day
165 Vertical GPS Velocity
166 North/South Velocity
174 East/West Velocity
247 Horizontal Figure of Merit
260 Date [BCD]
273 GNSS Sensor Status
355 GNSS Fault Summary
370 GNSS Height (HAE)
377 Equipment Hex ID Code (0Bh)
O
UTPUT
Installation Procedures
5
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
2-37