Table of Contents
Advertisement
Hardware Installation
1.2.2.2
Front Panel Overview
Call out
Description
A
Erase –
B
Power LED
•
•
C
Disk Activity LED
•
•
•
Port 3 (Management Port) – Out of band management
D
port used for configuration purposes. DHCP client is
enabled on this port from the factory.
Port 2 (WAN Port) – Connects to the WAN or upstream
E
router. DHCP enabled from the factory.
Port 1 (LAN Port) – Connects to the local network or
F
LAN. Factory configured for static IP with 192.168.1.1 IP
address.
8
Figure 1-3
Front view of the 5300
•
If pressed twice in quick succession,
the CLI password will be changed to
its original password.
•
If pressed three times in quick
succession, the 5300 will revert to
factory default settings. All passwords
will be reset and all prior
configurations will be erased.
Note: The default LAN address will be
set to 192.168.1.1
Caution: Setting the system
configuration to factory default will
erase all configuration changes.
Off – Power switch is off (or no power from the AC
outlet)
Solid Green – Power is supplied to the unit
Off – No disk activity
Flashing Red – Data is being read or written to the
disk.
Solid Red – System failure.
Chapter 1:
Hide quick links:
Advertisement
Table of Contents
