Mounting Installation; Din-Rail Mounting - Korenix JetCon 2502 User Manual

3. Mounting Installation

3-1. DIN-Rail Mounting

The DIN-Rail clip is attached in the box;
there are 2 clips with 4 screws.
The clip supports EN 50022 rail; screw
on the clips to the wall mount ears
before installing JetCon 2502 to the rail.
Refer to the diagram 3-1- 1.
After screwing on the clip, follow the
steps below to mount the JetCon 2502
to the standard DIN-Rail.
.
1. Insert the upper end of the DIN-Rail
clip into the back of the DIN-Rail track from its
upper side
2. Slightly press the bottom of the DIN-Rail clip into
the track.
3. Check if the DIN-Rail clip is tightly attached to
the track.
4. To remove JetCon 2502 from the track, use a
flat screw driver to loosen the clip from rail track.
See the diagram 3-1-2.
Figure 3-1-1
Figure 3-1-2
9