Table of Contents
Advertisement
2-3. Wiring the DC Power Inputs
Follow the steps below to wire JetCon 2502 DC power inputs.
[Note] Make sure the Switch Power module or AC/DC power adapter is
UL certified.
1.
Insert the positive and negative wires into the V+ and V- contacts respectively
of the terminal block connector
2.
Tighten the wire-clamp screws to prevent the DC wires from being loosened.
3.
The terminal block input and DC jack input supports power redundancy.
4.
The Chassis Earth Ground must well connect with Earth Ground to provide
good electrical magnetic immunity.
7
Hide quick links:
Advertisement
Table of Contents
