Page 1
PARAL YSER 755, 775, 775b &785 USER INSTRUCTIONS CYCL PS VEHICLE SOLUTIONS Proudly designed and engineered in Australia by Dynamco Pty Ltd. P755 P775 P775B 785 User - 2008.1 1 16/07/2008 3:24:11 PM...
Page 2
CYCL PS VEHICLE SOLUTIONS THIS CARD SHOULD NOT BE LEFT IN YOUR VEHICLE. IT MUST BE KEPT IN A SAFE SECURE PLACE. P755 P775 P775B 785 User - 2008.2 2 16/07/2008 3:24:11 PM...
OPERATIONS REMOTE CONTROLS All systems are supplied with two rolling code remote controls. Each time a button is pressed, the code advances to a completely new code. Each code is only ever used once. ARMING AND DISARMING To arm the system press the main button on the remote control. The vehicle indicators will flash twice.
ARM/DISARM SIREN CONFIRMATION Each time the alarm is armed the siren will chirp twice to confirm the arm operation. The siren will chirp if the automatic arming function arms the system. The siren will also chirp once when the system is disarmed by remote control.
DOME LIGHT FUNCTION When the system is disarmed by remote control, the internal circuitry can switch on the car’s dome light for 30 seconds. This feature will be cancelled if the driver turns the ignition switch to the ON position. Factory setting is disabled to avoid unit damage (see “Programmable Options”...
IMMOBILISATION The system includes two independent circuits of immobilisation. Each circuit starves the engine of one of it’s critical power supplies. The circuits are designed to be fail-secure, so if a would-be thief was to cut power to the immobiliser, the circuit design will ensure the car remains immobilised.
DIAGNOSTIC TABLE ZONE DESCRIPTION Bonnet Switch Auxiliary Trigger Doors / Boot Switch Glass Breakage EMERGENCY OVER-RIDE DUST CAP If either of the remote controls supplied with the system are lost, broken or stolen, the immobiliser can be disarmed LOCK by use of a security key and the unique 4 digit Personal Identification Number (PIN).
PIN OVER-RIDE PROCEDURE To illustrate the PIN over-ride procedure we will assume a PIN of 4,3,2,1. If indicators are still flashing, turn the ignition on and allow the system to reset with all doors closed. • Turn ignition switch to ON position, the status LED will remain lit. •...
PROGRAMMABLE OPTIONS The systems include 9 programmable options which alter the system functions to comply with the user’s preferences and vehicle special needs. OPTION CHANGE PROCEDURE • Disarm the system (status LED extinguished). • Open the driver’s side door, this must remain open throughout the whole procedure.
PROGRAMMABLE OPTION DESCRIPTIONS Option #3** the Anti Hijack feature locks the car doors when the ignition is switched on, except when a connected door is open. The anti hijack feature unlocks the doors when the ignition is switched off (when driver has reached destination). The feature is disabled if the dome light illumination is extended by the vehicle’s timing circuit.
Page 14
Option #11** determines whether the 30 seconds of siren output is constant or pulsed. The constant output suits a connection to a siren, which allows the siren to sound at full volume. The pulsed output suits the car horn. Option #13** Permanently enables or disables the arm/disarm silent mode.
A card with the PIN details must be supplied by your installer. Please contact your installer if the card is missing. Option #21 the alarm system can be set to produce an open door warning when arming. The warning is in the form of a short series of chirps from the siren or horn.
Test remote control by pressing main button. For further information, please contact your CASE TOP CASE TOP local Cyclops service centre. KEYRING KEYRING Remote battery type is CR2016. -16- P755 P775 P775B 785 User - 2008.16 16...
SPECIFICATIONS Manufactured by Dynamco Pty Ltd Model Number P755, P775, P775B, P785 Standards Compliance P755 AS/NZS 4601 P775 AS/NZS 4601 and AS/NZS 3749 P775B AS/NZS 4601 P785 AS/NZS 4601 and AS/NZS 3749 Supply Voltage +9VDC - +15VDC Current Consumption less than 20mA (while armed) Country of manufacture China (In Dynamco’s ISO-9002 facility) RF Transmission frequency...
System won’t disarm. LED on dash won’t extinguish. • Try spare remote control. • Use Emergency PIN to override system and contact nearest Cyclops service centre. • The remote fails to operate • If the remote fails to operate and the LED does not light up when the button is pressed then change the battery.
Insurance of the product whilst in transit to or from the Cyclops Service Centres. Cost of any service call / labour where the product is found by Cyclops to be in good working order. The benefits conferred by this Warranty are in addition to all other rights and remedies, which the consumer has conferred in law.
WARRANTY REGISTRATION PURCHASED FROM OWNER’S NAME TYPE OF VEHICLE VEHICLE REGO MODEL OF UNIT P.I.N DATE OF MANUFACTURE DATE OF INSTALL’ WARRANTY PERIOD CONTROL MODULE SIREN & REMOTES INSTALLER’S NAME AFTER HOURS EMERGENCY PHONE Production pack Version #1 -20- P755 P775 P775B 785 User - 2008.20 20 16/07/2008 3:24:14 PM...
Need help?
Do you have a question about the PARALYSER 755 and is the answer not in the manual?
Questions and answers