Subscribe to Our Youtube Channel
Related Manuals for CYCLOPS PARALYSER 355
Summary of Contents for CYCLOPS PARALYSER 355
- Page 1 PARAL YSER 355, 375, 375b &385 USER INSTRUCTIONS CYCL PS VEHICLE SOLUTIONS Proudly designed and engineered in Australia by Dynamco Pty Ltd. P355 P375 P375B 385 User - 2008.1 1 16/07/2008 3:20:41 PM...
- Page 2 CYCL PS VEHICLE SOLUTIONS THIS CARD SHOULD NOT BE LEFT IN YOUR VEHICLE. IT MUST BE KEPT IN A SAFE SECURE PLACE. P355 P375 P375B 385 User - 2008.2 2 16/07/2008 3:20:41 PM...
-
Page 3: Table Of Contents
Contents EMERGENCY OVER-RIDE PIN OVER-RIDE PROCEDURE INTRODUCTION PROGRAMMABLE OPTIONS OPERATIONS OPTION CHANGE PROCEDURE REMOTE CONTROLS PROGRAMMABLE OPTIONS TABLE ARMING AND DISARMING PROGRAMMABLE OPTION DESCRIP- ARM/DISARM SIREN CONFIRMATION TIONS SILENT ARMING CHANGING PIN CODE AUTOMATIC ARMING BATTERY REPLACEMENT DOME LIGHT FUNCTION SPECIFICATIONS PANIC FEATURE (Car Location) PROBLEM SOLVING... -
Page 4: Introduction
Please read this manual to gain a full understanding of what service a Cyclops 3 Series system can provide to you. LEGEND: P355 feature... -
Page 5: Operations
OPERATIONS REMOTE CONTROLS All systems are supplied with two rolling MAIN MAIN BUTTON BUTTON code remote controls. Each time a button is pressed, the code advances to a completely SECONDARY SECONDARY new code. Each code is only ever used once. BUTTON BUTTON ARMING AND DISARMING... -
Page 6: Arm/Disarm Siren Confirmation
ARM/DISARM SIREN CONFIRMATION Each time the alarm is armed the siren will chirp twice to confirm the arm operation. The siren will also chirp if the automatic arming function arms the system. The siren will also chirp once when the system is disarmed by remote control. -
Page 7: Dome Light Function
DOME LIGHT FUNCTION When the system is disarmed by remote control, the internal circuitry can switch on the car’s dome light for 30 seconds. This feature will be cancelled if the driver turns the ignition switch to the ON position. Factory setting is disabled to avoid unit damage (see “Programmable Options”... -
Page 8: Immobilisation
IMMOBILISATION The system includes two independent circuits of immobilisation. Each circuit starves the engine of one of it’s critical power supplies. The circuits are designed to be fail-secure, so if a would-be thief was to cut power to the immobiliser, the circuit design will ensure the car remains immobilised. -
Page 9: Diagnostic Table
DIAGNOSTIC TABLE ZONE DESCRIPTION Bonnet Switch Auxiliary Trigger Doors / Boot Switch Glass Breakage EMERGENCY OVER-RIDE DUST CAP If either of the remote controls supplied with the system are lost, broken or stolen, the immobiliser can be disarmed LOCK by use of a security key and the unique 4 digit Personal Identification Number (PIN). -
Page 10: Pin Over-Ride Procedure
PIN OVER-RIDE PROCEDURE To illustrate the PIN over-ride procedure we will assume a PIN of 4,3,2,1. If indicators are still flashing, turn the ignition on and allow the system to reset with all doors closed. • Turn ignition switch to ON position, the status LED will remain lit. •... -
Page 11: Programmable Options
PROGRAMMABLE OPTIONS The systems include 9 programmable options which alter the system functions to comply with the user’s preferences and vehicle special needs. OPTION CHANGE PROCEDURE • Disarm the system (status LED extinguished). • Open the driver’s side door, this must remain open throughout the whole procedure. -
Page 12: Programmable Options Table
PROGRAMMABLE OPTIONS TABLE IGNITION SWITCH TURNS 1 FLASH 3 FLASHES Anti Hijack DISABLED ENABLED Program New Remote Press remote Dome light upon disarm *** Disabled Enabled Horn / Siren Output Style Horn (pulsed) Siren (constant) Arm / Disarm audio confirm Enabled Disabled 120 Second re-lock... -
Page 13: Programmable Option Descriptions
PROGRAMMABLE OPTION DESCRIPTIONS Option #3** the Anti Hijack feature locks the car doors when the ignition is switched on, except when a connected door is open. The anti hijack feature unlocks the doors when the ignition is switched off (when driver has reached destination). The feature is disabled if the dome light illumination is extended by the vehicle’s timing circuit. - Page 14 Option #11** determines whether the 30 seconds of siren output is constant or pulsed. The constant output suits a connection to a siren, which allows the siren to sound at full volume. The pulsed output suits the car horn. Option #13** Permanently enables or disables the arm/disarm silent mode.
-
Page 15: Changing Pin Code
A card with the PIN details must be supplied by your installer. Please contact your installer if the card is missing. Option #21 the alarm system can be set to produce an open door warning when arming. The warning is in the form of a short series of chirps from the siren or horn. -
Page 16: Battery Replacement
CASE BOTTOM CASE BOTTOM original and re-assemble remote. Test remote control by pressing main button. For further information, please contact your local Cyclops service centre. Remote KEYRING KEYRING battery type is CR2016. REMOVE BATTERIES REMOVE BATTERIES... -
Page 17: Specifications
SPECIFICATIONS Manufactured by Dynamco Pty Ltd Model Number P355, P375, P375B, P385 Standards Compliance P355 AS/NZS 4601 P375 AS/NZS 4601 and AS/NZS 3749 P375B AS/NZS 4601 P385 AS/NZS 4601 and AS/NZS 3749 Supply Voltage +9VDC - +15VDC Current Consumption less than 20mA (while armed) Country of manufacture China (In Dynamco’s ISO-9002 facility) RF Transmission frequency... -
Page 18: Problem Solving
System won’t disarm. LED on dash won’t extinguish. • Try spare remote control. • Use Emergency PIN to override system and contact nearest Cyclops service centre. • The remote fails to operate • If the remote fails to operate and the LED does not light up when the button is pressed then change the battery. -
Page 19: Warranty
Insurance of the product whilst in transit to or from the Cyclops Service Centres. Cost of any service call / labour where the product is found by Cyclops to be in good working order. The benefits conferred by this Warranty are in addition to all other rights and remedies, which the consumer has conferred in law. -
Page 20: Warranty Registration
WARRANTY REGISTRATION PURCHASED FROM OWNER’S NAME TYPE OF VEHICLE VEHICLE REGO MODEL OF UNIT P.I.N DATE OF MANUFACTURE DATE OF INSTALL’ WARRANTY PERIOD CONTROL MODULE SIREN & REMOTES INSTALLER’S NAME AFTER HOURS EMERGENCY PHONE Production pack Version #1 -20- P355 P375 P375B 385 User - 2008.20 20 16/07/2008 3:20:43 PM...
Need help?
Do you have a question about the PARALYSER 355 and is the answer not in the manual?
Questions and answers