Advertisement
(EM) transmitting devices intended to be used with the radiating part of the
equipment in close proximity to the human ear including mobile phones, cordless
phones, etc. The frequency range is 300 MHz to 3 GHz. Therefore, the above text
does not address primary use of the wireless device product.]
Federal Communications Commission Notice (United States): Before a
wireless device model is available for sale to the public, it must be tested and
certified to the FCC that it does not exceed the limit established by the
government-adopted requirement for safe exposure.
The SAR limit adopted by the USA and Canada is 1.6 watts/kilogram (W/kg)
averaged over one gram of tissue. The highest SAR value reported to the FCC and
IC for this device type when tested for use is 0.480W/kg. [There is no reference to
the specific reference standard or its applicability to the intended use of the
product.]
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Class B Digital Device
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
HSUPA Statement
This device does not support high speed uplink packet access (HSUPA) at the
MIM802 Quick Start Manual, V1.0
Page 12 of 14
Advertisement
