With the KPN MIM802, you can access the Internet through wireless network at a high speed. Note: This manual briefs the profile of the KPN MIM802, and the preparation, installation and uninstallation process. For the operation of the management program, see the User Manual.
Indicator It indicates the status of the KPN MIM802. When the KPN MIM802 is powered on, the indicator is blinking in green. (The indicator is on for 100 ms and off for 100 ms, and then on for 100 ms and off for 2700 ms.)
Page 4
the indicator is blinking in blue. (The indicator is on for 100 ms and off for 2900 ms.) When the KPN MIM802 has been connected to a GPRS network, the indicator is on in green. When the KPN MIM802 has been connected to a WCDMA network, the ...
Getting Your KPN MIM802 Ready Insert the subscriber identity module/UMTS subscriber identity module (SIM/USIM) card into the slot of the KPN MIM802 with the golden contacts side facing upwards and the cut corner directing inwards. Follow the direction on the back of the KPN MIM802.
Otherwise, the normal installation of the KPN MIM802 can be affected. You can connect the KPN MIM802 to a computer with the USB data cable or the USB adapter. Two data cables are provided. One is short and single-ended. The other is long and double-ended.
Page 7
Select and stop the hardware related to the KPN MIM802. When the OS displays "It is safe to remove the device", remove the KPN MIM802. Note: Before removing the KPN MIM802, exit the Management Program.
Pacemaker manufacturers recommend that a minimum separation of 15 cm be maintained between a wireless device and a pacemaker to avoid potential interference with the pacemaker. Deactivate your wireless device, if it may have disturbance to the pacemaker MIM802 Quick Start Manual, V1.0 Page 8 of 14...
Page 9
Deactivate While Driving Do not use the wireless device while driving. Immunity to Interference Your wireless device is immune to interferences caused by audible signals. MIM802 Quick Start Manual, V1.0 Page 9 of 14...
CE Approval (European Union) The wireless device is approved to be used in the member states of the EU. KPN declares that the wireless device is in compliance with the essential requirements and other relevant provisions of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EC (R&TTE Directive).
Page 11
This is because the wireless device is designed to use the minimum power required to reach the network. All models of KPN's wireless device are designed to meet radio frequency exposure guidelines such as European Council Recommendation and Federal Communications Commission Notice (United States).
the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. HSUPA Statement This device does not support high speed uplink packet access (HSUPA) at the MIM802 Quick Start Manual, V1.0 Page 12 of 14...
Page 13
UMTS FDD Band II UMTS FDD Band V MIM802 Quick Start Manual, V1.0 Page 13 of 14...
Operating System Personal Identification Number Random-Access Memory Specific Absorption Rate Subscriber Identity Module UMTS Universal Mobile Telecommunications System Universal Serial Bus USIM UMTS Subscriber Identity Module WCDMA Wideband Code Division Multiple Access MIM802 Quick Start Manual, V1.0 Page 14 of 14...
Need help?
Do you have a question about the MIM802 and is the answer not in the manual?
Questions and answers