Lighting & Operation Label; Operating Instructions - A.O. Smith BTR 500 Instruction Manual

Series 120/121 commercial gas water heaters
Hide thumbs Also See for BTR 500:
Table of Contents

Advertisement

lighting & operation laBel
WARNING
A.
This appliance does not have a pilot. It is equipped with an ignition device which
automatically lights the burner. Do not try to light the burner by hand.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell
next to the floor because some gas is heavier than air and will settle on the floor.
"WHAT TO DO IF YOU SMELL GAS"
Do not try to light any appliance.
Do not touch any electric switch; do not use any telephone in your building.
Immediately call your gas supplier from a neighbor's telephone. Follow the
gas suppliers instructions.
STOP! Read the safety information above on this label.
1.
Set thermostat to lowest setting.
2.
Turn off all electric power to the appliance.
3.
4.
This appliance is equipped with an ignition device which automatically lights
the burner. Do not try to light the burner by hand.
5.
Push in gas control knobs slightly and turn clockwise
Wait five(5) minutes to clear out any gas. If you then smell gas,
6.
Follow "B" in the safety information above on this label. If you
smell gas, go on to next step.
Turn gas control knobs counterclockwise
7.
Turn on all electric power to the appliance.
8.
9.
Set thermostat to desired setting.
If the appliance will not operate, follow the instructions "To Turn Off Gas To Appliance"
10.
and call your service technician or gas supplier.
Set the thermostat to lowest setting.
1.
Turn off all electric power to appliance if service is to be performed.
2.
FOR YOUR SAFETY READ BEFORE OPERATING
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury, or loss of life.

OPERATING INSTRUCTIONS

GAS
CONTROL
KNOBS
to off.
STOP!.
don't
to "ON".
FOR YOUR SAFETY READ BEFORE OPERATING
If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in or turn the gas control knob. Never use tools. If
the knob will not push in or turn by hand, don't try to repair it. Call a qualified
service technician. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a
qualified service technician to inspect the appliance and to replace any part of
the control system and any gas control which has been under water.
PSI
IN
PSI
IN
Push in gas control knobs slightly and turn clockwise
3.
figure 22
24
FLAMMABLE
ON
OFF
ON
OFF
to "OFF". Do not force.

Advertisement

Table of Contents
loading

Table of Contents