Kernel Multi Check User Manual page 31

NOTE:
The best puncture site is on the side of fingertip, because it has the best blood supply.
6. Press the trigger on the puncturer.
7. Lift up the puncturer.
8. Get a drop of blood.
9. Put the drop of blood on one side or the other side
of the test strip target area. The blood will be absorbed
and cause the target area to turn red. The testing reaction
starts when the meter beeps. The meter will start to
count down 20 seconds then show your result on the screen.
The meter stores your result in its memory automatically.
NOTE:
How much blood should be applied?
Although only a small amount of blood is needed, it is very important
that you put enough blood on your test strip so that the entire reaction zone
is covered with blood. This ensures that your meter can give accurate and
reliable results.
Cautions:
If you don't apply enough blood, You might need to use a new test strip to do the test again.
10. In about 20 seconds, the screen will display measured uric acid value.
Record the uric acid value in your log book.
31