Table of Contents
Advertisement
Input
Connections
VHF / UHF
VHF / UHF antenna to rear panel "VHF /
UHF" F type connector.
Cable
Connect cable feed to rear panel "Cable" F type
connector.
High Definition
Connect an UHF antenna to the DTV Receiver
TV
(external set-back box) and the receiver to the
rear of the TV using the supplied multi-pin I/O
cable.
DVD, Video 1-
Connect the video and audio cables of the
3, or HD
DVD, VCR, game, or camcorder to the rear
panel phono jacks. The video 2 input is located
on the front panel.
The HD box has component video (Y, R-Y, B-
Y) outputs. They plug into the HD input
(phono jacks).
Input Selection
Programming Steps
1.
Power ON.
2.
Use the remote TV/Video button to select TV.
3.
The remote ANT button toggles between VHF / UHF
and cable. Select VHF / UHF (channel number
without a C prefix).
rd
4.
From the 4
Menu icon, select & enter "Auto
Program: VHF / UHF".
5.
Use Channel Up/Dwn to change stations for normal
operation.
1.
Power ON.
2.
Use the remote TV/Video button to select TV.
3.
The remote ANT button toggles between VHF / UHF
and cable. Cable station numbers are preceded with a
letter "C". Select a C prefix station like C4.
rd
4.
From the 4
Menu icon, select & enter "Auto
Program: Cable".
5.
Use Channel Up/Dwn to change stations for normal
operation.
1.
Power ON.
2.
Use the remote TV/Video button to select TV.
3.
The remote ANT button toggles between VHF / UHF
and cable. Select VHF / UHF (without a C prefix).
rd
4.
From the 4
Menu icon, select & enter "Auto
Program: VHF / UHF". This tells the set-back box
to auto program DTV stations too. ("DTV Auto Add"
is only used to add DTV stations after one was
found.).
5.
Use Channel Up/Dwn to change stations for HDTV
reception.
1.
Power ON.
2.
Use the remote TV/Video button to select the desired
input.
20
Results
1.
See previous Power ON chart.
2.
Snow or a TV station with a channel
number will appear if you are correctly in
the TV mode.
3.
Correct VHF / UHF channels will be
numbered 2-69. Cable channels are
preceded with a letter C like C78.
4.
It takes almost 1 min. to scan through all
the VHF / UHF stations. At the end it will
select the lowest active VHF station.
1.
See previous Power ON chart.
2.
Snow or a TV station with a channel
number will appear if you are correctly in
the TV mode.
3.
Correct Cable channels will be displayed
as C1 to C125.
4.
It takes about 1 min. to scan through all the
cable stations. At the end it will select the
lowest number active cable station.
1.
See previous Power ON chart.
2.
Snow or a TV station with a channel
number will appear if you are correctly in
the TV mode.
3.
Correct VHF / UHF channels will be
numbered 2-69. Cable channels are
preceded with a letter C like C78.
4.
It takes about 1 min. to scan through all the
VHF/UHF stations. At the end it will select
the lowest number active station.
1.
See previous Power ON chart.
2.
The OSD will show the input selected as
you press the TV/Video button. The input
sequence is: Video 1-3, DVD, HD, TV and
it repeats.
Advertisement
Table of Contents
