Download Print this page

WebGate WebEye A10 User Manual page 5

Audio transmission kit
Hide thumbs Also See for WebEye A10:

Advertisement

IV. Specifications of WebEye A10
Operating S/W
Audio Compression
Input (Microphone)
External
Communication
Power supply
Mechanical
Usable Accessary
V. Reference Facts
1. Access Condition
Audio quality depends on upload rate of Internet, Round Trip time between user and
WebEye, and Packet loss degree.
When WebEye is connected to ADSL/ISDN/PPP or connection state is bad, audio may
be cut off or may not be operated normally regardless of video transmission quality.
2. H/W, S/W Configuration
When volume is low, control master volume and wave volume at 'control panel' in PC,
and configure volume at WebEye Administration Page. (In needed, use external
amplification speaker.)
When you utilize A10 for audio transmission, use external microphone for it.
O/S: Windows 98/ME/NT/2000
Web browser: MS Internet Explorer (Version 4.0 or above)
Software: WebEye Audio S/W (Active-X Control from WebEye
E10/E104)
Compression type: TrueSpeech 8.5 Engine
H/W Codec: CT8022 (DSP inside TrueSpeech Codec)
Sample dimension: A -law 8 bit
Sampling rate: 8000 Hz
Transfer rate: 8 Kbps
Impedance: Max. 2.2KΩ
Sensitivity: -36dB ~ -40dB
Standard power supply: 4.5V DC
Serial: RS232C, 38400bps
Cable: 8Pin RJ -45 Modular Jack to D-Sub 15pin
Accessable Clients at the same time: Max. 50 (in using LAN)
DC 12V, 1.0A
Dimension: 94mm x 81mm x 28mm
Weight: 180g (without adaptor)
External Mic.(Condensor Mic.)

Advertisement

loading