Scott DJX 60 TT User Manual page 7

CONTROLS OVERVIEW
4. Center Spindle
This spindle holds the turntable PLATTER records
stable and centered.
5. Strobe Indicators Pilot Lamp
This is lamp specially designed to pulse a beam of
light at the STROBE INDICATORS on the turntable
PLATTER. The backlighting varies depending on the
pitch adjustment.
6. Power Switch
This is a rotary power switch. To turn the main power
on, turn the switch clockwise. To turn the main power
off turn the switch counterclockwise.
7. Start/Stop Button
This oversized push button controls the platter motion.
When the unit is turned on the platter will not
automatically begin to spin. Pressing the button once
will engage the high torque motor and spin the platter.
Press it again to stop the platter.
8. Headshell
The included headshell is used to connect your stylus
to the tone arm.
9. Headshell Locking Nut
After attaching the headshell to the tone arm, this
locking nut will securely hold the headshell to the tone
arm.
10. S-Shaped Tone Arm
The tone arm is the mechanism that holds the
headshell and stylus, allowing it to glide across a
record.
11. 33-RPM Speed Select Button
Press this button to rotate the platter at 33 revolutions
per minute (RPMs). A function LED will glow when
this function is activated.
12. 45- RPM Speed Select Button
Press this button to rotate the platter at 45 RPMs. A
function LED will glow when this function is activated.
13. Pitch Control Slider
This slider is used to adjust the playback pitch
percentage (platter speed).
14. Tone Arm Lever
This lever is used to safely elevate the tone arm
above a record surface without damaging its surface.
15. Tone Arm Clamp and Rest
Use this rest to safely hold the tone arm in position
during non-use and transportation.
16. Anti-skate button
The anti-skate mechanism applies inward force to the
tone arm to prevent outward skipping across the
record due to the centrifugal force cause by platter
rotation. Adjust the anti-skate value so that it is equal
to that of the stylus pressure.
17. Stylus-Pressure Ring
＊ The scale must face toward the DJ.
18. Extra Stylus Headshell Holder
This cut out has been designed to safely store an
extra stylus headshell.
19. Counterweight
Use the counterweight to balance the tone arm and to
adjust the stylus pressure.
20. Hinge For Dust Cover
21. USB Socket (USB cable limit within 3m)
After connecting the Turntable to the computer via a
USB cable, you can record your vinyl to a hard disk
using the included Audacity software.
22. Phono/Line Selector
This switch is used to select phono output mode or
line output mode.
23. RCA output Jacks
The outputs can be used as to PHONO outputs or
LINE outputs. For example: These jacks are used to
send a low voltage "phono" level output signal to a
mixer's "phono" input jacks. Turntables should be
connected to "Phono" inputs on a mixer. The red RCA
jack represents the right channel input and the white
jack represents the left channel input.
GB6