Connecting To Dc Disconnect - Sharp JH-1600E Installation & Operation Manual

Connecting to DC Disconnect

This section describes the connection between the solar power inverter and the DC disconnect from the PV string.
Follow all WARNING and CAUTION of Wiring Solar Power Inverter (page 9).
(1) Install two copper wires (positive and negative) from the DC disconnect through the
conduit.
(2) Attach a forked spade or lug connector to the cables before connecting to the terminal
block.
Pass the wire through the gland before connecting to the terminal.
Make sure DC disconnect is open.
DC terminal block for DC disconnect
13