Activating/Deactivating Of The Lock-Out Mode; (Device Pin Needed) - Digittrade High Security HS128 User Manual

4.2 Activating/deactivating of the lock-out mode

(Device PIN needed)

In the activated Lock-Out Mode access to the data is instantly stop-
ped if the smart card is removed.
The HS128 / HS256 is factory set with lock out mode active. The „STATUS"- LED
illuminates red during the authentication process.
The user can deactivate this feature in particular situations. This must be done
when only one smart card has access to many different storage devices that are
supposed to be unlocked at the same time but have the same cryptographic key.
When the lock-out mode is deactivated the „STATUS"-LED illuminates green du-
ring the authentication process.
Follow these steps to activate/deactivate the Lock-out mode:
1) Insert the smart card into the DIGITTRADE HS128 / HS256.
Paying attention that the „STATUS"-LED flashes once.
Note: if the „ERROR"-LED illuminates after inserting the smart card, please initialise
the smart card as described in chapter 5.4.
2) Press the „ADMIN"-button and then the „1".
3) Press „ENTER". The „STATUS"-LED flashes three times.
4) Input your 8-digit device pin and press „ENTER".
If the PIN was entered correctly the „STATUS"-LED flashes three times and
you will hear two beep sounds.
5) The Lock-out mode is now activated/deactivated. The „STATUS"-LED
illuminates red when the feature is activated and green when it is deactivated.
6) disconnect the USB connection to the DIGITTRADE HS128 / HS256 and
reconnect to
Note: The Lock-Out mode is factory set to active. Do not remove the smart card
from the DIGITTRADE HS128 / HS256 in this mode, as it can lead to data loss.
leave this feature.
51