MSS APE 50 (2012)
Disassemble the carburettor removing the mini-
mum jet, the needle, the gaskets, the petrol filter.
REVISION
The carburettor is completely decomposed, check
all calibrated parts (main jets, idle jets, emulsifiers
tubes, etc.).
The value of these calibrated parts must corre-
spond to the adjustment data prescribed for the
type of carburettor.
For a thorough cleaning of all components of the
carburettor, use a bath of suitable solvent and blow
with compressed air.
To clean the calibrated jets, avoid using metallic
spikes or wires.
All gaskets, seal rings and springs of the carbu-
rettor, should be replaced with each revision.
FITTING
Refit the carburettor, being careful to replace all gaskets, the sealing rings, and the springs.
Install the carburettor on the engine and fit the air filter.
Air filter
REMOVAL
Remove the fixing nuts and the air filter cover.
Tracking ID-422/tukxi/04/2013
Maintenance
MA - 33