Assembly; Plastic Shield Installation; Nylon Line Head Installation - Echo SRM-280U Operator's Manual

Hide thumbs Also See for SRM-280U:

Table of Contents

SRM-280U

ASSEMBLY

(Nylon line operation)

Parts Required:

Plastic Debris Shield, Shield Plate,

three (3) 5 x 16 mm screws.

The plastic shield is for use with the Nylon Line Head only.

Install Metal Shield when using plastic or metal blades, or

serious injury may result.

1. Align hole in upper plate (A) with notch in gear housing (B), and insert locking tool (G) to prevent splined

shaft from turning. Arrow on gear housing flange points to notch location.

2. Remove cotter pin (C), L.H. blade nut (D), lower plate (E),

and upper plate (A) from PTO shaft (F). Turn blade nut

clockwise to remove.

3. Remove locking tool (G). Retain lower plate (E) and blade

nut (D), for future use with blade conversions.

4. Align plastic debris shield (H) with the drive shaft, and install

on the bottom of the gear housing flange.

5. Place shield plate (I) on shield, align holes and install three

(3) screws.

6. Replace upper plate (A) on PTO shaft (F).

Parts Required:

Nylon Line Head.

Wear Gloves or personal injury may result:

• Cutoff knife is sharp.

• Gearcase and surrounding area may be hot.

1. Make sure plastic debris shield (H) is properly aligned, and

upper plate (A) is installed on splined PTO shaft (F).

2. Align hole in upper plate (A) with notch in gear housing (B), and insert locking tool (G) to prevent splined

shaft from turning.

X7502310908

ASSEMBLY

Table of Contents