Water Circulation System - Buderus 500-24S Installation And Maintenance Instructions Manual

V Mount the lower bracket on the wall and attach the
manifold assembly. If the manifold does not sit flat,
check the orientation of the lower wall-spacing bracket
( fig. 8).
V Make the pipework connections to the manifold.
See also subsection 1.8.
V Open the case locking mechanism, using a radiator key
( fig. 5, item 1). The radiator key is included in the
delivery of the boiler, in the accessory bag.
V Remove the boiler case.
V Remove the polystyrene foam piece from the top of the
boiler.
Note
If the boiler is not to be connected the pipe-
work immediately, then place caps on the
pipe connections.
V Connect the manifold unions to the boiler, using the
seals supplied.
V Hang the boiler (
fig. 9) onto the upper wall-spacing
frame bracket.
1.7

Water circulation system

The central heating system should be installed in accord-
ance with BS.6798 and, in addition, for smallbore and
microbore systems, BS.5449 or EN 12823.
Buderus 500-24S - Subject to modifications resulting from technical improvements
Fig. 8 Mounting the manifold
Fig. 9 Hanging the boiler
1
Installation
7215 3100-08.1TD
7215 3100-09.1TD
13