Turning On The Unit - Cercon Clean 230VAC Instructions For Use Manual

Fig. 2: Section through unit, viewed from the left
10 Plastic connector for filter bag
11 Filter bag
12 Basket
15 Duct, 63 mm in diameter
16 Duct, 40 mm in diameter
17 Cover for filter bag
20 Pre-filtration chamber
21 Floor rollers
22 Screws for bottom space (9 ea.)
23 Vacuum motor

2.3 Turning on the unit

(see Figs. 1 and 2 on page 4)
1. Check the filtration module (see Section 3.1).
2. Connect the 40-mm diameter hose to the milling unit (keeping the hose as
short as possible; the maximum length is approximately 2 m).
24 Sealing surfaces, circumferential
25 Seal, circumferential
26 Air intake opening
27 Air intake chamber
28 M6 nuts (2 ea.)
29 Ledge with longitudinal bores
30 Electrical wiring central
31 Ultra-fine filter
32 Ultra-fine filtration chamber
6/15