Table of Contents
Advertisement
Fig. 5. Inserting the filter bag
2.
Slide the new filter bag (11) in its basket (12) into the unit. The duct of the
filter bag (10) will engage the duct (15) inside the filtration chamber (20)
tightly.
3.
Slide the plastic connector (10) tightly onto the housing duct (15) of the
vacuum unit.
4.
Place the cover (2) on the housing (1) and tighten using the clamp locks (3).
4.3 Cleaning (replacing) the ultra-fine filter
(see Figs. 1 and 2 on page 4 and Fig. 6 on page 9)
Note
Approximately every tenth time the filter bag (11) is changed, the ultra-fine
filter (31) should be removed and cleaned (dry cleaning process) or
replaced.
We will be happy to clean the ultra-fine filters (31) for you by way of a filter
exchange. In this way you can be certain that only type-tested filters
pursuant to DIN EN 60 335-2-69 (ZH 1/487 para. 2 with a certificate
pursuant to DIN 24184) are used.
1.
Open the two clamp locks (3) and remove the cover (2).
2.
Open and remove the thumb screws (6) and und mounting cover (5).
10/15
Advertisement
Table of Contents
