Check Program Data - JVC Model SR-TS1U Instructions Manual

44
EN
1
4
7
NUMBER "8"
CANCEL
STOP+/–
PROG.
1
ATTENTION
If there is a conflict in the timer schedule and one program
overlaps with another, only the parts shown below in gray
will be recorded.
Pattern 1: The program with the lower program number
will be recorded.
10:00
Program 1
Program 2
Pattern 2: The program that is broadcast earlier will be
recorded.
10:00
Program 1
Program 2
Pattern 3: The program that is broadcast earlier will be
recorded, followed by the remaining portion of
the other program.
10:00
Program 1
Program 2
2 3
2
5 6
8 9
TIMER
0
4
OK
11:00 12:00
CH10
Not recorded
CH40
11:00 12:00
CH10
Not recorded
CH40
11:00 12:00
CH10
CH40
Not recorded
TIMER RECORDING (cont.)

CHECK PROGRAM DATA

5
The PlusCode number you
entered and the matching
Timer-Recording informa-
tion is displayed on the
Program screen. Check to
make sure it's accurate.
To change the stop time,
press STOP +/–.
To timer-record daily or weekly serials, press DAILY
(NUMBER "8") or WEEKLY (NUMBER "9"). "DAILY"
or "WEEKLY" appears on the Program screen.
Pressing the button again makes each corresponding
display disappear.
If you made a mistake, press CANCEL to access the
VCR Plus+ screen again and input the correct
PlusCode number.
If the PlusCode number you inputted is incorrect,
"ERROR" may appear on the screen to advise you of
the error. This happens when the PlusCode number is
for a program which has already passed. "ERROR" is
displayed for about 5 seconds and the VCR Plus+
screen reappears.
SET TAPE SPEED
6
Press SP/EP.
RETURN TO NORMAL
SCREEN
7
Press PROG. or OK. "PROGRAM COMPLETED"
appears on the screen for about 5 seconds, then normal
screen appears.
ENGAGE TIMER MODE
8
Press TIMER. The VCR turns off automatically and "‰" is
displayed on the display panel.
IMPORTANT
If you have moved to a different area or if a broadcasting
station's channel number has been changed, the wrong
VCR or CABLE CH number will be displayed on the
VCR Plus+ program screen in step 5. When this happens,
set the correct Guide Channel number for that station. (
pg. 45, "VCR Plus+ Setup")
NOTES:
To disengage the timer before recording starts, press TIMER
again. Pressing once more re-engages it.
In case of a power failure after programming, the VCR's
memory backup keeps your selections (if the lithium battery is
not exhausted).
When timer-recording cable channels received through a
Cable Box, be sure to keep the Cable Box set to ON.
PROGRAM 1
(VCR PLUS+ 12345678)
START STOP
=
8:00PM 10:00PM
DATE CH
12/24/99 12 SP
THU
PRESS (8=DAILY, 9=WEEKLY
STOP+/– = STOP TIME, SP/EP)
PRESS (OK) TO END