How To Connect Your Bcm2604-L/Bcm2604-F - Baracoda USB Plug User Manual

3.3 How to connect your BCM2604-L/BCM2604-F

1. Reset the scanner by taking out and replacing both batteries.
2. If the scanner has not been programmed to read the Code 128 symbology, scan the Code 128
active barcode ("Code 128 on"). The scanner should beep. The LED should remain a single
flashing light. Immediately reset the scanner. This will clear the memory buffer and allow the
pairing barcode to operate correctly.
for the BCM2604-L
3. Plug the dongle into the USB port of the computer.
4. Wait 5 seconds for the host computer to recognize the USB Plug & Scan dongle. It is possible
that the host computer will not recognize the dongle: this can be corrected by going to the control
panel hardware wizard and searching for a USB HID device.
5. Do not scan any other barcodes except the 'connect barcode' that is delivered with the
dongle.
6. You will immediately get a "good read" confirmation beep from the scanner. In case you don't get
an immediate double beep, simply reset your scanner and try again.
7. The scanner will beep a second time: the LED on the scanner will start double flashing green: you
are now paired and connected! (*)
8. Open up the target application (such as Notepad, Excel and Word). Make sure the application can
accept data from a keyboard and the active cursor is where the user wants the barcode
information to be placed.
9. Start scanning barcodes. Please note that the USB Plug & Scan is not able to transmit 2D
barcodes with an amount of information bigger than 1080 characters.
(**) If the LED on the BL/BC/BLR2604 is not double flashing a green light, this may possibly
mean:
•
The scanner is low on power. Charge the unit up completely and try again
•
The scanner has not been reset. Reset it and try again
•
The scanner has been programmed from its default status and it is not able to decode the
Code 128 symbology. Be aware that the pairing barcode is a code128 and so the scanner
shall stay in its default mode "Code128 on"
June 07
USB Plug & Scan Dongle - User Guide
Code 128 on
© Baracoda 2007
FOR THE BCM2604-F
8