Wheel Alignment, Balancing, Catalytic Converter Maintenance - TATA Motors Xenon Owner's Manual & Service Book

Ofrecido por www.electromanuales.com

WHEEL ALIGNMENT, BALANCING, CATALYTIC CONVERTER MAINTENANCE

Wheel Alignment :
Incorrect wheel alignment causes
excessive and uneven tyre wear.
Check wheel alignment at
specified intervals.
alignment values are given below :
0
Caster : 3 ± 30 '
0
Camber : 0 ± 30 '
Toe in : 2 to 5 mm
On vehicles with torsion bar
suspension, wheel alignment
needs to be checked only after
adjusting chassis height as per
procedure. Chassis height for 16
inch tyre is 510 ± 3 mm Check
and maintain tyre pressure
periodically to obtain longer tyre
life.
Wheel Balancing :
Wheels of your vehicle are
balanced for better ride comfort
and longer tyre life. Balancing
Wheel needs to be done whenever tyre
is removed from rim.
1. Permissible imbalance for tyre
with rim = 250 gm-cm max.
2. Total balance weight should be
within 140 gms on each side.
3. Relocate the tyre if the weight
required to balance is more
than 140 gms.
4. Balance weights are available
from 10 gms to 140 gms in
steps of every 10 gms and from
15 gms to 135 gms in steps of
every 10 gms.
5. Do not use more than one
balance weight on one side.
Maintenance
Care for the Catalytic Converter
The catalytic Converter does not
require any special maintenance
however, following precaution
should be taken for the effective
functioning of the converter and
to avoid damage to the Converter.
It is mandatory to use Diesel
fuel with sulphur content less
than 0.035 %. Use of any other
diesel fuel can increase the
pollutants.
CAUTION
Avoid parking the vehicle over
inflammable materials, such as
dry leaves, grass etc., as the
exhaust system is hot enough
to initiate 'FIRE'.
101