T-V Link Functions - JVC LPT0543-001A Instructions Manual

T-V LINK
T-V Link
Functions
When you connect the recorder and your TV via a fully-wired
21-pin SCART cable ( pg. 6), the following functions are
available. You can use these functions only with a TV offering
T-V Link, etc.*
For details, refer to the instruction manual for your TV.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link, DATA LOGIC or NexTView Link via fully-
wired 21-pin SCART cable. The degree of compatibility and
available functions may differ by system.
NexTView Link
You can download the EPG (Electronic Programme Guide)
information from your TV for timer-programming on the
recorder.
For details, refer to the instruction manual for your TV.
TV Auto Power On
You can turn on the TV and set it to video mode automatically
whenever you play a tape.
For details, refer to the instruction manual for your TV.
NOTE:
"TV Auto Power On" of T-V LINK functions is not possible with
the DV deck.
VCR Auto Standby
You can use your TV's remote control to turn off the recorder.
For details, refer to the instruction manual for your TV.
Direct Rec
You can start recording the programme that you are watching
on your TV with simple operation. Press and hold RECORD and
press PLAY on the remote control, or press RECORD on the
recorder.
Follow the procedure below to use this function.
TURN ON THE RECORDER
1
Press .
ACCESS MAIN MENU
SCREEN
2
Press MENU.
ACCESS MODE SET
SCREEN
3
Press %fi to move the
highlight bar (pointer) to
"MODE SET", then press
#
OK or .
SELECT DIRECT REC MODE
4
Press %fi to move the
highlight bar (pointer) to
"DIRECT REC", then press
#
OK or to set to "ON".
RETURN TO NORMAL
SCREEN
5
Press MENU.
NOTES:
If "DIRECT REC" is set to "OFF", the RECORD button functions
as described in "Recording" (
During the Direct Rec, "– –" appears on the display panel.
When you perform T-V LINK functions, be sure to use a fully-
wired 21-pin SCART cable.
Retake function does not work during Direct Rec (
Direct Rec is not possible with a scrambled broadcast.
To record a scrambled broadcast, set "DIRECT REC" to "OFF"
and follow the procedure described in "Recording" on page
17, 18.
11
MAIN MENU
MODE SET
VHS MODE SET
DV MODE SET
AUTO CH SET
MANUAL CH SET
OUTPUT/INPUT SET
INITIAL SET
[5∞] =
[MENU] : EXIT
MODE SET
S-VHS/AUDIO OUT AUTO
O. S. D. ON
AUTO TIMER OFF
DIRECT REC ON
POWER SAVE OFF
[5∞] =
[MENU] : EXIT
pg. 17, 18) .
pg. 58).