Set Dss Receiver Brand - JVC HR-VP830U Instructions Manual

24
• • •
• •
• •
• •
• •
1
4
NUMBER
7
MENU
NOTES:
Depending on the type of DSS receiver, it is possible that the
Controller will not work with it.
If your DSS receiver doesn't respond to the code, you can't
use the Controller to change satellite channels. In this case,
make sure to leave the DSS receiver turned on and tuned to
the proper channel before the scheduled start of timer
recording.
The VCR can only change the satellite channel through the
Controller during timer recording.
If your DSS receiver is one that can't be operated with a
remote control (has no remote sensor), you can't use the
Controller to change its channels. Make sure to leave the DSS
receiver turned on and tuned to the proper channel before the
scheduled start of timer recording.
If you are unable to set the Controller, please contact JVC toll
free at 1-800-252-5722.
8
ENTER
2 3
5 6
8 9
0
CH
OK
TIME SCAN
INITIAL SETTINGS (cont.)

Set DSS Receiver Brand

TURN ON DSS RECEIVER
1
Select a channel other than channel 205 on your DSS
receiver.
ACCESS DSS RECEIVER
BRAND SET SCREEN
2
At the Custom Set screen,
press CH 5 ∞ or TIME
SCAN 5 ∞ to place the
arrow next to "DSS
RECEIVER BRAND SET",
then press OK.
ENTER DSS RECEIVER
BRAND
3
Press the appropriate
NUMBER keys to enter the
DSS Receiver Code from
the following list, then
press ENTER.
The unit is pre-set to code
80 (RCA) when shipped.
If the DSS receiver's
channel changes to 205, setting is complete.
BRAND
RCA
SONY
RETURN TO NORMAL
SCREEN
4
Press MENU as many times as necessary.
CUSTOM SET
OVERRIDE
AUTO CLOCK SET
LANGUAGE SELECT
VCR PLUS+ SET-UP
DSS RECEIVER OUTPUT
=DSS RECEIVER BRAND SET
PRESS ( 5 ,∞), THEN (OK)
PRESS (MENU) TO END
DSS RECEIVER BRAND SET
80
SELECT BRAND NO. AND
PRESS (ENTER)
PRESS (MENU) TO END
CODE
80
81