Setup And Configuration - Cardo Systems Scala Rider FM User Manual

| SCALA RIDER
Wall Charger
Allen Wrench
Velcro Pads
MP3 Cable
Glue Plate
Pre-moistened Towelette
Carry-Pouch
Microphone Sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form
IMPORTANT:
The SCALA RIDER FM is a water-resistant device, designed for use
under moderate rain or snow conditions. However, the headset is not
waterproof and should not be used under severe weather conditions.
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least four hours
before initial use.
1. Connect the wall charger to the headset's Charging Jack (located
between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to 15
seconds until the Red Light turns on). When charging is complete,
the Red Light will turn off.
FM™
®
SET UP AND CONFIGURATION
FM Radio
Mobile Phone
SET UP FOR MOBILE PHONE CALLS
If you have a Bluetooth enabled mobile phone and would like
to make and receive phone calls using the SCALA RIDER FM,
you must first pair your headset to the mobile phone.
Pairing is a one time process. Once the headset is paired to a
specific mobile phone during this Setup Procedure, they will
remain paired and automatically recognize each other whenever
they are within range. If the connection between the phone and
headset is lost, tap the CTRL button to reconnect the devices.
TO PAIR THE SCALA RIDER FM TO A BLUETOOTH MOBILE PHONE
1. Turn on your phone and make sure its Bluetooth function is
activated.
2. With the SCALA RIDER FM headset turned OFF, press and
hold the CTRL Button until the Red and Blue Lights begin
rapidly alternating.
4
GPS
MP3 Player