Advertisement
OPERATING
Lighting instructions
1.
Ensure that bottle is connected and supply valve open (LPG).
2.
Press control knob in and turn to pilot setting.
3.
Hold control knob in and allow at least one and a half minutes for air to
purge from gas line. Slightly tilting the heater will assist the air to purge.
4.
While still pressing knob, turn to "star" setting.
5.
If the pilot has not ignited, repeat the procedure.
6.
The knob must be held in at the "star" setting for a further 20 seconds to
allow flame failure device to engage.
7.
Release knob (slowly) and turn to the flame setting required.
Changing a bottle (LPG).
When the flame turns abnormally yellow and becomes smaller it is time to
change the gas bottle. To do this simply slide the round cylinder cover up the
main stem to expose the gas cylinder. Remove the leg held on with a wing nut.
Disconnect regulator from the bottle and exchange bottles.
Dome Removal.
The reflective dome is designed to be easily removed so the Patio Heater can be
wheeled through doorways etc. This should only be done after the heater has
been off for sufficient time to fully cool down.
Abnormal performance.
If at any time the Patio Heater exhibits any problem or abnormal noise it should
be immediately turned off. The Patio heater should be checked and tested by
authorised service technician before being used.
Page 6 of 9
PIAZZA PATIO HEATER
10/04/07
Advertisement
