Table of Contents
Advertisement
OPERATING
Lighting instructions
WARNING: Do not operate if any covers are removed.
1.
Ensure that Gas Supply is connected and supply valve open.
2.
Ensure the Mains supply is connected and switched on.
3.
Turn on, the on/off switch, the micro-processor starts its pre purge lighting
sequence. Spark is initiated after about 8 seconds and continue to spark for 4
seconds to ignite the gas.
Turning off instructions
1.
Turn off the on/off switch, the valve will de-energised so stopping the gas supply.
Abnormal performance.
If at any time the Patio Heater exhibits any problem or abnormal noise it should
be immediately turned off. The MEZZO Hanging Patio heater should be
checked and tested by authorised service technician before being used.
SERVICING
CAUTION: Only authorised service technicians should undertake any repairs or
Maintenance on this product.
To access components there are covers that can be removed from the perforated stainless
steel cylinder that surrounds the control. This is done by removing the screws on these
covers.
As with all gas appliances, regular servicing will improve the trouble free operation of this
appliance. This service should cover the following
- Leak test all joints
- Check operating pressures
- Clean main gas orifices
- Clean main burner venturi as insects and dirt may gather there.
- Brush any soot etc. that may have gathered on stainless steel mesh.
Page 7 of 12
Mezzo Hanging Patio Heater
29/10/10
Advertisement
Table of Contents
