Table of Contents
Advertisement
STEP 5
Install RO Tap (continued)
I I NSTALL REVERSE OSMOSIS TAP
5
Locate and organize your RO Tap install parts. See packing list on page 1
6
R,S,T
Route the 3 tubes
attached to the RO Tap Body
P
RO Tap Body
to the RO Tap Base
tubing remains above the sink. Lay RO Tap Body
7
P
Mount Tap Body
to the sink hole by pushing the toggle bolts through the hole until the RO Tap Body
surface. Position the toggle bolts to catch under the lower surface of the sink or counter, but ensure that they will not obstruct
the tap stem from sitting in place. Loosely tighten the toggle bolts until the RO Tap Base
TIP: Make sure to keep the "wings" of the toggle bolts free to allow all tubing and tap stem room
TIP: Install the tap base with the bolts at 5 and 11 o'clock positions to have the handle positioned at 90 degrees to the right
8
Q
Hold the RO Tap Base
firmly and mount the RO Tap Body
the RO Tap Body Handle is positioned to your liking.
TIP: If there is not enough clearance for the tubing and the stem, the toggle wings may need to be adjusted to create more
clearance.
9
P
Turn the RO Tap Body
1/4 turn counter-clockwise and remove the tap enough to tighten the RO Tap Base
screws firmly. Do not over-tighten.
1 0
P
Mount the RO Tap Body
to the RO Tap Base
1 1
O
Mount the RO Tap Spout
to the RO Tap Body
P
through the RO Tap Base
Q
R,S,T
yet. Then route the 3 tubes
P
on the counter top.
P
to the RO Tap Base
Q
and turn 1/4 turn clockwise until it locks.
P
by screwing spout nut to body.
Q
, but don't connect the
through the hole in the sink until 12" of
P
is flat against the sink
Q
is mounted loosely to the surface.
Q
by turning 1/4 clockwise to lock. Ensure
Q
toggle bolt
7
5
O
Q
P
R
S
T
Advertisement
Table of Contents
Need help?
Do you have a question about the PTL RO System and is the answer not in the manual?
Questions and answers