STEP 2
Install RO Drain Connector
Be sure that all electrical appliances and outlets are turned off at the
circuit breaker before working in cabinet area.
Drain Connector Installation
Choose the drain outlet location. See Fig. 1 (page 3)
1
Remove protective cover from back of Foam Seal
K
front plate
.
2
K
Position the Drain Connector
on the sink drain pipe above the drain trap. Allow room for drilling. Tighten Screws
M
Nuts
securely.
3
Use a battery powered or properly grounded drill. Using the Drain Connector
the wall of the drain pipe. Do NOT penetrate the opposite side of the pipe and be careful not to damage the side of the drain
port fitting.
4
If you wish to install your drain in a remote location refer to page 10.
STEP 3
Install RO Filter System Assembly
The Reverse Osmosis Filter System Assembly Head
C
The Mounting Screws
allow you to lift the RO Filter System Assembly without any hardware removal.
1
Choose an easy-to-access area under the sink to mount the RO Filter System Head
NOTE: To allow adequate space for filter changes, allow clearance of 4" - 6"below the filter
System Assembly must be mounted in a vertical position.
NOTE: Mount the Filter System Head to a solid cabinet wall or wall. If a solid surface is not available, use hollow-wall
anchor bolts or toggle bolts (not included) to secure to the wall.
2
Using the Built-in Bracket on the back of the RO System Head
wall surface.
3
Using a 1/8" drill bit, drill two pilot holes for the Mounting Screws
Phillips screwdriver, leaving approximately 3/8" of each Mounting Screw
4
A
Hang the RO System Head
on the Mounting Screws
WARNING
N.
Knock out center hole and align holes then attach to Drain Connector
K
port as a drill guide, drill a 7/32" hole through
A
is mounted on Mounting Screws
A
, mark the holes for the Mounting Screws
C
. Insert Mounting Screws
C
exposed.
C
.
CAUTION
Please wear safety glasses to protect
eyes when drilling.
L
and
C
.
A
.
to
the floor. The Filter
C
on the
C
into the wall with a
5
Need help?
Do you have a question about the PTL RO System and is the answer not in the manual?
Questions and answers