Spectrum PTL RO System Installation Instructions Manual page 11

STEP 7
Install RO System and Drain In Remote Location
I I NSTALL A REMOTE DRAIN POINT AND AIR GAP (Remote Location)
You can also run the drain tubing to an existing drain in the house. A floor drain, laundry tub, standpipe,
sump, etc. are suitable drain points.
Always be sure to provide an air gap between the end of the hose and the drain point. This will prevent
water from backing up into the system.
TO INSTALL A REMOTE DRAIN POINT, COMPLETE THE FOLLOWING STEPS:
1 R
Remove the 1/4" Red Plastic Tubing
2
Determine if this length is long enough to reach the drain point. If it is, then insert Restrictor
tubing and then insert this end of tubing into drain port on RO Membrane Filter
3
If not, replace the 1/4" Red Plastic Tubing
I
Then insert Restrictor in end of tubing and then insert this end of tubing into drain port on RO
B 2
Membrane Filter . Refer to Step 6 in manual on how to disconnect and connect tubing.
4
Run the tubing to the drain point and secure at the end with a bracket (purchased locally).
Provide a 1-1/2" air gap between the end of the tube and the drain.
5 T
Remove 3/8" White Plastic Tubing
6
Tap will not have 1/4" or 3/8" tubing attached to the airgap barbs in the RO Tap Body
remote installation.
P
from the RO Tap Body by pulling gently.
B 2
R
with an adequate length of tubing to reach the drain point.
P
from RO Tap Body and discard.
I
in end of
.
P
for
10