Cessna , 337 Skymaster Assembly Manual page 14

CESSNA 337 SKYMASTER
MOUNTING THE ENGINE AFTER.
1) Position the engine with the drive washer
(110mm) forward of the firewall as shown.
105mm.
2) Use a pin drill and 2mm drill bit to drill a
small indentation in the mount for the engine
mounting screw.
3) Use a drill to drill the four holes in the engine
mount rails.
14
2mm
2mm diameter.
Instruction Manual.
4) On the fire wall has the location for the
throttle pusshrod tube (pre-drill).
5) Slide the pushrod tube in the firewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the firewall
and the fuel tank mount.
6) Connect the Z-bend in the 450mm throttle
pushrod to the outer hole of the carburetor
arm.
7) Slide the throttle pushrod wire into the
tube. Position the engine between the
mounts. Use four 3x15mm machine screws to
secure the engine to the mount as shown.
Machine screw M3x25mm.
Screw.
Pushrod wire.
Pushrod tube hole.