Cessna , 337 Skymaster Assembly Manual page 13

Table of Contents

Advertisement

3) Use a drill to drill the four holes in the engine
mount rails.
4) On the fire wall has the location for the
throttle pusshrod tube (pre-drill).
5) Slide the pushrod tube in the firewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the firewall
and the fuel tank mount.
6) Connect the Z-bend in the 450mm throttle
pushrod to the outer hole of the carburetor
arm.
7) Slide the throttle pushrod wire into the
tube. Position the engine between the
mounts. Use four 3x15mm machine screws to
secure the engine to the mount as shown.
www.seagullmodels.com
2mm
M3x15mm.
Pushrod tube hole.
Pushrod wire.
Trim and cut.
Machine screw M3x15mm.
9) Move the throttle stick to the closed position
and move the carburetor to closed. Use a 2.5mm
hex wrench to tighten the screw that secures
the throttle pushrod wire. Make sure to use
threadlock on the screw so it does not vibrate
loose.
Linkage.
.
13

Advertisement

Table of Contents
loading

Table of Contents