Meridian DSP User Manual page 40

DSP7000
It is the nature of all lacquer fi nishes to shrink over time. This is
unavoidable and may result in cabinet joint lines becoming visible.
Meridian Audio has supplied products using lacquer fi nishes for many years
and we are confi dent that when carefully used your product will return a
lifetime's enjoyment.
Tightening the drive units
The DSP loudspeakers typically take about two weeks of normal use for the
drive units to settle. It is therefore recommended that you tighten the
mounting bolts on each drive unit every few days during this period.
Tighten the bolts in symmetrically opposite pairs using the 3mm hex
wrench supplied.
You should then check and if necessary retighten the drive units every few
years.
Removing the grilles
The grille is guided into position on plugs, and held fi rmly on the speaker
with Velcro fasteners. To remove the grille pull it gently, starting from the
bottom edge, allowing time for the Velcro to disengage. Then pull it evenly
away from the sides until it is free. Replace the grille after tightening the
drive units.
33