Meridian DSP User Manual page 22

DSP5200 AND
DSP5200HC
Meridian Audio has supplied products using lacquer fi nishes for many years
and we are confi dent that when carefully used your product will return a
lifetime's enjoyment.
To fi t the feet (DSP5200 only)
The feet ensure that the loudspeakers have a stable base, and can be
adjusted to allow for uneven fl oors. Use the spikes for carpeted fl oors; they
are designed to penetrate the pile without damaging or fl attening the
carpet. Retract the spikes for solid fl oors.
Each DSP loudspeaker needs four feet, fi tted as follows:
• Insert the spike into the foot so that the nut engages in the hexagonal
• On solid fl oors retract the spike so it does not extend below the foot
• When all four feet have been fi tted, carefully set the DSP loudspeakers
• On carpeted fl oors, adjust the spikes until the speakers are stable, and
To fi t the rubber bumpons (DSP5200HC only)
• Attach four bumpons to the underside of each speaker, using the self-
Tightening the drive units
The DSP loudspeakers typically take about two weeks of normal use for the
drive units to settle. It is therefore recommended that you tighten the
mounting bolts on each drive unit every few days during this period.
Tighten the bolts in symmetrically opposite pairs using the 3mm hex
wrench supplied.
You should then check and if necessary retighten the drive units every few
years.
recess in the bottom of the foot, and screw each spike into the threads
on the bottom of the loudspeaker. Do not fully tighten the lock nuts at
this stage.
cap.
upright in their playing positions and remove the rest of the packaging.
then tighten the lock nuts using the feet as wrenches. If you need
additional length on the spikes you can remove the feet and use the
spikes and lock nuts on their own.
adhesive pads.
15