Front Fog Lamp; Side Repeater Lamp; Rear Tail/Stop, Turn Signal, Back-Up And Fog Lamps - Jeep Cherokee Owner's Manual

Front Fog Lamp

1. Open the hood.
2. Reach behind the headlamp housing to
access the bulb.
3. Rotate the bulb's socket counterclockwise,
and remove the bulb and socket assembly from
the fog lamp housing.
4. Pull the bulb out of the socket and insert the
replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
5. Install the bulb and socket assembly into the
fog lamp housing, and rotate the connector
clockwise to lock it in place.
6. Close the hood.

Side Repeater Lamp

1. Push the side repeater lens to one side to
release the spring tension and then pull it
outward.
2. Disconnect the bulb from the harness con-
nector and then connect the replacement bulb.
3. Engage the right hook of the side repeater
lamp into the sheet metal (note correct orienta-
tion of lettering on lens).
4. Rotate the side repeater lamp in place until
the left side engages (you will hear a light
click).
Rear Tail/Stop, Turn Signal, Back-Up
and Fog Lamps
1. Open the liftgate.
2. Remove the screws that fasten the taillamp
housing to the vehicle.
3. Pull the taillamp housing straight back to
separate it from the vehicle.
4. Disconnect the electrical connector.
5. Remove the two screws that fasten the back
plate to the taillamp housing.
6. Separate the back plate from the taillamp
housing.
7. Pull the appropriate bulb(s) out of the back
plate and insert the replacement bulb(s).
8. Install the back plate and screws into the
taillamp housing.
9. Connect the electrical connector.
10. Install the taillamp housing and screws.
11. Close the liftgate.
237