XC‐14A, XC‐22A, XC‐30A USER'S MANUAL Portable Air Conditioners
closed position.
5. Replace the clean filter and close the filter guard.
6. To clean the condenser filter, lift up on the rear filter from the
middle bar slightly and then angle the filter outwards from the
bottom and remove.
7. Use the same cleaning procedure as in steps 3‐5 above.
8. To replace the condenser filter, place the top of the filter in the
guide and slide the filter up until the bottom of the filter clears
the frame. Then push the bottom of the filter into the guide and
let the filter gently fall inside the guide.
NOTE: For effective cooling, clean the filter at least every 2 weeks.
WARNING
DO NOT operate without the filter installed
DO NOT operate the unit with a damaged cord or
WARNING
plug, after the unit malfunctions, or if the unit has
been dropped or damaged.
Spring Replacement
There are two springs on the rear of the condenser water tank
guide.
1. Release the screw on the spring hook.
2. Take off the spring hook, and then pull out the opposite spring
hook from the hole in the condenser
water tank guide.
3. Replace with a new spring in reverse
order.
4. Repeat these steps for the other
spring.
Page 14
Xtreme Power Conversion® (XPC) Corporation
Figure 9 – Spring Replacement
XC‐14A, XC‐22A, XC‐30A USER'S MANUAL Portable Air Conditioners
OPERATION
Control Panel
Figure 6 – Control Panel
1. POWER BUTTON
Activates unit when POWER BUTTON is pressed.
Fan starts on low speed.
If POWER BUTTON is pressed during operation, unit
stops.
2. BLOWER BUTTON
Changes fan speed from LOW to HIGH when pressed.
3. SPOT / COOL BUTTON
Activates compressor and begins producing cool air 2
minutes after button is pressed.
Regulates temperature based on outlet cool air
temperature.
4. ROOM / COOL BUTTON
Activates compressor and produces cool air 2 minutes
after button is pressed.
Regulates temperature based on inlet ambient air
temperature.
Xtreme Power Conversion® (XPC) Corporation Page 11