Timer Recording; G- Code System Setup; G- Code Timer Programming - JVC HR-S7600AM Instructions Manual

28
EN
G-
CODE
System Setup
Turn on the TV and select the VIDEO channel (or AV mode).
1
4
7
1
MENU
INFORMATION
G- and S V
CODE HOW IEW
represent the same easy recording feature, but only the term
G- system will be used in the instructions. If you use the
CODE
S V system, follow the same instructions listed for
HOW IEW
the G- system.
CODE
2 3
2
5 6
8 9
0
4
OK
PUSH JOG
are different trademarks used to
The G-
CODE
input channel, date, start and stop time data when setting the
timer record function. Simply key in the G-
TV programme you wish to record (found in most TV listings)
and the recorder's timer is automatically programmed.
You have to set "GUIDE PROG" numbers, which are assigned to
each station for purposes of G-
stations stored in your recorder's memory to get proper results.
Before G-
procedures:
Tuner setting (
Clock setting (
IMPORTANT
Perform the following procedure after Auto Set Up on page 8
and/or the channel setting steps on pages 52 – 55.
After setting the Guide Program Numbers, channel positions
may be incorrect if you stored or skipped channels. In this case,
re-perform Guide Program Number setting.
Guide Program Number Set
NUMBER
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS INITIAL SET
SCREEN
2
Press PUSH JOG %fi to place the pointer next to
"INITIAL SET", then press OK or PUSH JOG
ACCESS G-CODE/
SHOWVIEW SETUP
SCREEN
3
Press PUSH JOG %fi to place the pointer next to
"G-CODE/SHOWVIEW SETUP", then press OK or
PUSH JOG
ENTER GUIDE PROG
NUMBER
4
Press PUSH JOG %fi or
NUMBER keys to enter the
Guide Program number for
the desired station as shown
in the TV listings. Then press
OK or PUSH JOG

TIMER RECORDING

timer programming system eliminates the need to
timer programming, for all the
CODE
setup you must have performed the following
CODE
pg. 8, 52)
pg. 12)
.
.
number for the
CODE
.
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2 5
[0-9] OR [5/ ∞ ]:SELECT =
[MENU] : EXIT