Rear Wheel Spacers (All Models) - TiLite Aero 2GX Owner's Manual

Rear Wheel Spacers
(All Models)
Adjusting Rear Wheel Spacing
Tools required:
• 7/8" open-ended wrench
• 3/4" open-ended wrench
• Torque Wrench
I
WARNING
Do not use spacers exceeding a total of 3/4". If more than 3/4" of the axle
sleeve is outside of the camber plug, the axle sleeve could disengage
from the camber plug while you are using the chair. If you ignore this
Warning, you may fall, tip over or lose control of the wheelchair and
seriously injure yourself or others or damage the wheelchair.
1. Place the 7/8" open-end wrench onto the camber plug and use the
3/4" open-end wrench to remove the axle sleeve. See Figure 106.
2. Add or delete the spacers you need to increase/decrease your rear
wheel spacing.
3. After you have adjusted your rear wheel spacing, reinstall the axle
sleeve in the camber plug and hand tighten.
4. Using a torque wrench, tighten the axle sleeve to 230 inch-pounds.
OM_FOLDING_0907RevB
CHAPTER 12: REAR WHEELS
67
Folding Owners Manual