Chapter 5: Armrests - TiLite Aero 2GX Owner's Manual

Hide thumbs Also See for Aero 2GX:

Owner's manual (103 pages)

Table Of Contents

Table of Contents

Tubular Swing Away Armrest

(2GX, Aero X, SX, TX, X, and XC)

To swing away the armrest, lift the armrest and rotate the armrest away

from chair. See Figures 26-28. On the 2GX, TX, XC and Aero X, make

sure to lift the armrest until the armrest pins are above the notch on the

armrest receiver. See Figures 26 and 27.

To replace the armrest, rotate the armrest back towards the chair and

gently push it down into place. See Figures 25-27. On the TX, XC and

Aero X, make sure the armrest pins are in the notch on the armrest

receiver. See Figures 27 and 28.

Note: On all TiLite wheelchairs, the swing away armrests pivot on nylon

sleeves, located inside the armrest receiver. If the armrest does not rotate

properly, check the nylon sleeves for wear.

Adjusting the Height of the Tubular Swing Away Armrest

(2GX, Aero X, TX and XC)

Tools Needed:

• 2 5/32" Allen Wrenches

1. Remove the armrest from the armrest receiver.

2. Remove both armrest pins. See Figure 29.

3. Reassemble the armrest pins in the desired location on the armrest

(in 3/4" increments).

4. Securely tighten both armrest pins in the new location.

5. Reinstall the armrest in the armrest receiver.

Adjusting the height of the Tubular Swing Away Armrest

Receiver

(2GX and Aero X)

Tools Needed:

• 5/32" Allen Wrench

• 7/16" Open End Wrench

1. Remove the armrest from the armrest receiver.

2. Remove the two Allen Screws pass through the frame and the armrest

receiver. See Figure 30.

3. Reposition the armrest receiver to the desired height and reinsert the

Allen Screws. Securely tighten the Allen Screws and Locknuts.

4. Reinstall the armrest in the armrest receiver.

Adjusting the Height on the Armrest Receiver

(SX and X)

Tools Needed:

• 5/32" Allen Wrench

• 7/16" Open End Wrench

Note: Unless you ordered anti-tippers for your X or SX chair, the armrest

receiver may be raised or lowered to achieve a higher or lower height for

the swing away armrest.

1. Remove the armrest from the armrest receiver.

OM_FOLDING_0907RevB