Getting To Know Your Electric Ceramic Kettle; Electric Power; Before Using For The First Time; Product View And Parts - Bella electrical kettle User Manual

ELECTriC POWEr

If the electrical circuit is overloaded with other appliances, your appliance may not operate
properly. It should be operated on a separate electrical circuit from other appliances.

gETTiNg TO KNOW YOur ELECTriC CErAmiC KETTLE

Product may vary slightly from illustration
Lid Handle
Ceramic Body
Cord Exit Slot
(below switch)
Lighted ON/OFF Switch
3 Prong Plug
(not shown)

BEFOrE uSiNg FOr ThE FirST TimE

1. Boil a kettle of water following the Operating Instructions described in this Instruction Manual.
2. Discard the boiled water. Your kettle is now ready for use.

OPErATiNg iNSTruCTiONS

CAUTION: Do not immerse power base, power cord, or plug in water or any other liquid.
1. Position the power base on a stable, level surface near an electrical outlet.
Unwind the power cord from the cord storage area located beneath the power base.
Make sure the cord exits through the cord exit slot on the side of the power base.
2. Check that the ON/OFF switch is in the OFF (up) position.
3. Remove the kettle from the power base. Use the lid handle to remove the lid.
Fill with fresh, cold water to the desired level. The kettle yields up to 5 cups (1.2 liters) of
water. Add water to at least the MIN water level; do not fill above the MAX water level.
Wipe excess water off the kettle.
CAUTION: Never add water above the MAX water level. This could cause boiling water
to splatter out.
NOTE: If the kettle is accidentally switched ON without sufficient water,
a boil-dry protection device will automatically turn the unit OFF. (See Boil-Dry Protection
explanation in this Instruction Manual.)
SO-309716_13724 BELLA Ceramic Kettle IM.indd 4
Lid
4
Spout
Power Base
Electrical Connector
12-06-27 5:01 PM