Boil-Dry Protection; User Maintenance Instructions; Care & Cleaning Instructions - Bella electrical kettle User Manual

4. Check to be sure the sealing ring is properly assembled onto the lid. Close the lid
and press down gently until it snaps into position to ensure it is fully closed.
Otherwise the kettle may not turn OFF after boiling.
CAUTION: To avoid the risk of splashing while pouring hot water, make sure the lid
is securely closed onto the kettle before operation.
5. Place the kettle on the power base, taking care not to spill any water.
6. Plug the power cord into a 120V AC electrical outlet. Press the ON/OFF switch down to
the ON position. The lighted button will illuminate. Water will begin heating immediately.
7. When a rolling boil is reached, the lighted button will then turn off; the ON/OFF switch
will lift (up) automatically and the kettle will turn OFF.
NOTE: The kettle can be turned OFF any time during the heating process by lifting
the ON/OFF switch up.
WARNING: This appliance generates heat and escaping steam during use.
Proper precautions must be taken to prevent the risk of burns, fires, or other injury to
persons or damage to property. Keep hands and face clear of the area above the kettle.
8. Grasp the handle and carefully lift the kettle from the power base before pouring.
CAUTION: Always check that the ON/OFF switch is in the OFF (up) position before
removing it from the power base.
CAUTION: To avoid a risk of splashing, make sure the lid is securely closed onto the kettle
before operating. Pour slowly and be careful not over-tilt the kettle.
CAUTION: Do not touch hot surfaces!
9. To reheat, check the water level to ensure it is above the MIN water level. If necessary,
add more water before returning the kettle to the power base.
10. Allow at least 30 seconds before pressing the ON/OFF switch down to the ON position.
11. When not in use unplug the power cord from the wall outlet. Allow the unit to cool
completely before cleaning. Empty the kettle after each use. Do not allow water to sit
in the kettle overnight. See User Maintenance Instructions.

Boil-Dry Protection

A safety thermostat will automatically turn the kettle OFF whenever the unit is without
sufficient water, or if the kettle is allowed to boil dry. To reset the boil-dry protection device,
remove the kettle from the power base and allow it to cool before refilling with water.

USer MAintenAnce inStrUctionS

This appliance requires little maintenance. It contains no user serviceable parts. Do not try
to repair it yourself. Any servicing requiring disassembly must be performed by a qualified
appliance repair technician.
cAre & cleAning inStrUctionS
CAUTION: Always unplug kettle and allow to cool before cleaning. Never immerse kettle,
power base, cord, or plug in water or other liquids. Never use scouring pads or harsh
cleansers to clean your kettle as they may damage the surface.
1. Make sure the kettle is unplugged and completely cool.
2. Grasp the handle and remove the kettle from the power base. If necessary,
wipe the inside and outside of the kettle with a soft, damp cloth and wipe dry.
3. Wipe the power base with a damp cloth.
4. Make sure both the power base and kettle are completely dry after cleaning and before use.
SO-309716_13724 BELLA Ceramic Kettle IM.indd 5
5
12-06-27 5:01 PM