Table of Contents
Advertisement
Required hardware (included):
Required tools (not supplied):
1
Position the template. Install the center push pin.
2
Level the template. Install the second push pin.
3
Using a pencil trace two keyholes located on the template.
4
Using a 1/8-inch drill bit, drill two pilot holes located
on the template.
5
Remove the template.
6
If a pilot hole does not hit a stud use a 1/4-inch drill
bit to widen the hole and install a wall anchor.
7
Install both wall brackets using only the top screw. Do
not over tighten the top screw.
8
Align each wall bracket's keyhole with a traced key-
hole and tighten the top screw.
9
On the back of the Feature, install two shoulder bolts
10
Installation
in the top holes and two rubber bumpers in the bottom
holes. Test fit the speaker. Adjust the bracket positions
until the speaker fits. IMPORTANT! At this point do not
allow the speaker to hang freely—there are not enough
screws installed to fully support its weight.
10 Drill two more pilot holes (per bracket) at the screw hole
locations on the left & right sides of both wall brackets.
11 If a pilot hole does not hit a stud remove the wall brack-
et, use a 1/4-inch drill bit to widen the hole, and install
a wall anchor.
12 Install both wall brackets using all 3 screws per brack-
et. Tighten the screws.
13 Hang the speaker on the wall brackets.
Figure 6 . Vertical Hardware Configuration
Figure 7 . Horizontal Hardware Configuration
Advertisement
Table of Contents
