Edit To Or From Another Vcr - JVC HR-S3800U Instructions Manual

46
EN
Edit To Or
From Another
VCR
Connection
Ex. When using this VCR as the playback VCR
To S VIDEO
OUT
S-video cable
(supplied)
To S-video
Input
Another VCR (for recording)
You can use your VCR as the playback or recording VCR.
c Refer also to the other VCR's instruction manual for
connection and its operations.
1
Make connections
Connect an audio/video cable between the
playback VCR's audio/video output connectors
and the recording VCR's audio/video input
connectors.
c When using this VCR as the recording VCR,
connect this VCR's audio/video input
connectors to the audio/video output
connectors on the other VCR.
If the playback VCR is monaural, connect the
audio output connector on the playback VCR
to the left audio input connector on this VCR.
HR-S4800U/S3800U-EN44-53
This VCR (for playback)
REMOTE
IN OUT
PAUSE/ ANTENNA IN
AV
R
CABLE COMPU
BOX -LINK
AUDIO
IN OUT L
VHF/UHF
S
TV OUT
V
VIDEO
I
D
CH3 CH4
E
O
To AUDIO/
VIDEO OUT
Audio/video
cable (supplied)
To Audio/
video Input
46
2
Load cassettes
Insert the playback cassette into the playback
VCR and the cassette to be recorded on into the
recording VCR.
3 Select input mode on recording VCR
Select the correct external input on the other
VCR.
c On this VCR (when using this VCR as the
recording VCR);
Select "L-1" — when connecting the other VCR
to the audio/video input connectors on
the rear panel;
Select "F-1" — when connecting the other VCR
to the audio/video input connectors on
the front panel.
On the front panel:
Press CH5∞.
On the Remote:
Press the Number key "0 (AUX)" or CH +/–.
NOTE:
When using this VCR as the recording VCR, set the
video input terminal setting correctly ( Z pg. 38 and
42).
4
Select edit mode
Set the edit mode to "ON" for the VCRs if such a
mode is equipped.
c On this VCR, set "PICTURE CONTROL" to
"EDIT" by following the procedure described
on pages 38 and 39.
5
Start playback
Press PLAY ( 3 ) on the playback VCR.
NOTE:
If the playback VCR is equipped with a superimpose/
OSD disable feature then set it to "OFF" before starting
playback ( Z pg. 38 and 39).
6
Start recording
Press REC ( ¶ ) on the recording VCR.
NOTE:
Be sure to select "AUTO" for "PICTURE CONTROL" (or
"NORM" when "VIDEO CALIBRATION" is set to "OFF") after
you finish dubbing the tapes ( Z pg. 38 and 39).
00.1.31, 10:02 AM
EDITING (cont.)