Remote Control Functions - JVC HR-J880EU Instructions Manual

REMOTE CONTROL
Remote Control
Functions
PULL/OPEN
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A code
signals because your video recorder is initially set to respond to
A code signals. You can easily modify your video recorder to
respond to B code signals.
A
Press and hold VCR on the remote control for over 2
seconds, press the number key "2" and then press OK.
The remote control now can transmit B code signals.
B
24H EXPRESS
PR
PUSH/TURN
Press and hold 4 on the recorder for more than
5 seconds while the recorder is turned off. The code
currently set appears on the front display panel.
C
Press any key on the remote control. The recorder will
now only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above, but in step 1, press the number
key "1" instead of "2".
Set the remote control code.
Check the remote control code for the
recorder.
Change the code for the recorder.
35
EN