Hour Express Timer Programming - JVC HR-J880EU Instructions Manual

30
EN
24 Hour Express
Timer Programming
Before performing the 24 Hour Express Timer
Programming:
Make sure that the recorder's built-in clock is set properly.
Insert a cassette with the safety tab in place. The recorder
will come on automatically.
Set the tape speed.
PULL/OPEN
You can programme a timer recording that starts within 24 hours
using the JOG dial on the recorder.
A
Press 24H EXPRESS # on the recorder. The start time
indicator (
The current tape speed and VPS/PDC setting appear on the
front display panel, but it is impossible to change the setting.
You can only change the setting after programming
(
B
Turn the JOG dial to the left or right to set the time you
want recording to start.
One click stop of the JOG dial changes the time in 5-minute
intervals.
24H EXPRESS
PR
PUSH/TURN
Push the JOG dial. The stop time indicator (
blinking on the front display panel. Turn the JOG dial to
the left or right to set the time you want recording to stop.
Push the JOG dial. Turn the JOG dial to the left or right to
select the channel you wish to record.
You can cancel the setting at any time by pressing and holding
the JOG dial for more than 3 seconds or pressing & on the
remote control. Repeat the step 2.
C
Press 24H EXPRESS #. The recorder turns off
automatically and
To disengage the timer mode, press
24H EXPRESS
TIMER RECORDING (cont.)
Enter the programme mode.
) starts blinking on the front display panel.
pg. 32).
Set the programme start/stop time and
channel.
Engage the recorder's timer mode.
#
appears on the front display panel.
#
again.
) starts
#
(TIMER) or